No customs fees! Products from within the EU
HPE Networking Comware Switch 48G PoE+ 4SFP+ EI 5140
MPN: JL824A
Quick Code: B45809106
(FLEXNETWORK 5140 48G POE+ - 4SFP+ EI SWITCH)
Note: Image accuracy is not guaranteed. Please do not rely solely on the image for your purchase.
$7115.72
$8538.86 inc. VAT
All products on this website are available duty-free in the EU
Overseas Customers with EU-VAT number do not pay VAT. - Verify it here
Overseas Customers with EU-VAT number do not pay VAT. - Verify it here
Quick Code:
B45809106
MPN:
JL824A
Manufacturer:
HPE
EAN Code:
💰 Get $51.23 Cash Back if paying by Debit Card or Bank Transfer!
NOTE: The information below is provided for your convenience only and we cannot guarantee its accuracy. If necessary, please verify with us before purchasing.
Management features
| Switch type | Managed |
| Switch layer | L3 |
| Quality of Service (QoS) support | ✅ |
| Web-based management | ✅ |
Ports & interfaces
| Basic switching RJ-45 Ethernet ports quantity | 48 |
| Basic switching RJ-45 Ethernet ports type | Gigabit Ethernet (10/100/1000) |
| Installed SFP modules quantity | 0 |
| Installed SFP+ modules quantity | 0 |
| SFP+ module slots quantity | 4 |
| Console port | RJ-45 |
Network
| Networking standards | IEEE 802.1AX, IEEE 802.1D, IEEE 802.1Q, IEEE 802.1ab, IEEE 802.1ad, IEEE 802.1ak, IEEE 802.1p, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ac, IEEE 802.3ad, IEEE 802.3ae, IEEE 802.3af, IEEE 802.3at, IEEE 802.3az, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z |
| 10G support | ✅ |
| Full duplex | ✅ |
| IP routing | ✅ |
| Flow control support | ✅ |
| Link aggregation | ✅ |
| Broadcast storm control | ✅ |
| Auto MDI/MDI-X | ✅ |
| Spanning tree protocol | ✅ |
| Auto-sensing | ✅ |
| VLAN support | ✅ |
Data transmission
| MAC address table | 16384 entries |
| Switching capacity | 176 Gbit/s |
| Throughput | 131 Mpps |
| Latency (1 Gbps) | 5 µs |
| Latency (10 Gbps) | 3 µs |
| Jumbo frames support | ✅ |
Security
| DHCP features | DHCP server |
| Access Control List (ACL) | ✅ |
| IGMP snooping | ✅ |
| Authentication | MAC-based authentication |
| Authentication type | HWTACACS, RADIUS |
Multicast features
| Multicast support | ✅ |
Protocols
| Routing protocols | OSPF, OSPFv2, OSPFv3, RIP, RIP-1, RIP-2 |
| IPv4 FIB entries | 512 |
| IPv6 FIB entries | 256 |
Design
| Rack mounting | ✅ |
| Stackable | ✅ |
| Form factor | 1U |
Performance
| Physical stacking (units) | 9 |
| Memory type | SDRAM |
| Internal memory | 512 MB |
| Flash memory | 256 MB |
Power
| Power source | AC |
| Power supply included | ✅ |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| DC input voltage | 54 - 57 V |
| Power consumption (max) | 478 W |
| Power consumption note | 478W (Maximum), 47W (Idle) Notes: Idle power is the actual power consumption of the device with no ports connected. Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. PoE power is the power supplied by the internal power supply. When supplemented with the use of an HPE RPS1600, up to 740W of PoE+ can be supplied. Maximum current rating for DC power is 25A. AC input power is 47W typical and 490W maximum (including 370W PoE+ consumption). DC input voltage range is –54 VDC to –57 VDC. Total DC input power is 43W typical and 890W with 800W PoE+ power consumption. DC input voltage range is –54 VDC to –57 VDC. DC input source is the HPE RPS1600. |
| Power supply note | At least 1 power supply is required (not included, must be ordered separately) |
Power over Ethernet (PoE)
| Power over Ethernet (PoE) | ✅ |
| Total Power over Ethernet (PoE) budget | 370 W |
Other features
| Latency | 1000 Mb latency: < 5 µs 10 Gbps latency: < 3 µs |
| Memory and processor | 512 MB SDRAM, 256 MB flash |
| Performance management | HPE Aruba Networking IMC - Intelligent Management Center; SmartMC; Command-line interface; Web browser; SNMP manager |
| I/O ports | 48 RJ-45 autosensing 10/100/1000 ports (IEEE 802.3 Type 10BASE T, IEEE 802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T); Duplex: Ports 1-48 support 10BASE-T/100BASE-TX, 1000BASE-T (full only); 4 SFP+ 1000/10000 SFP+ ports; 1 RJ-45 serial console port |
| Weight (imperial) | 6 kg (13.2 lbs) |
| Dimensions (W x D x H) (imperial) | 43.7 x 439.9 x 399.8 mm (1.72 x 17.3 x 15.7") |
Operational conditions
| Operating temperature (T-T) | -5 - 45 °C |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating relative humidity (H-H) | 10 - 90% |
| Storage relative humidity (H-H) | 5 - 95% |
| Heat dissipation | 1671 BTU/h |
Weight & dimensions
| Width | 43.6 mm |
| Depth | 440 mm |
| Height | 400 mm |
| Weight | 6 kg |
Logistics data
| Harmonized System (HS) code | 85176990 |